Floor Wrap^TM Film is a white paint booth floor covering film.

Designed to provide a bright, reflective surface. Improves visibily to the lower areas on the vehicle. Makes it easier to maintain a clean environment. Effective in all booths, especially today’s high turbulence paint booths designed for water-borne finishes. Change the film as often as desired. The film can be left in place for up to four months.

Floor Wrap Film is Bright White and 4 mils thick. It is 36 inches wide by either 120 feet or 500 feet lengths. The 120 foot roll is enough to do the floor of an oversize paint booth once. For economy, the 500 foot roll will do it 4 times for the cost of 3 -120 foot rolls.

Floor Wrap Film can also be used in the mixing room on the floor, countertop, backsplash and around the paint recycler container.

DIRECTIONS FOR USE:
Apply to a clean, smooth hard floor suface. Ceramic tile, polished and sealed concrete or epoxy coated. It is easiest to apply by two people. Unroll a few feet. Pull the film tight from both ends. Hold the film close to the floor at the free end. Adjust for position. Apply the free end to the floor. Smooth down the first couple of feet by hand. Then, use a soft-bristled floor broom to smooth out the air and wrinkles as the roll end is lowered and pulled across the floor.

At the start of each day, sweep the floor and blow out the booth to remove loose material.